◉SpeakerFoundryFREE DRIVER RESOURCES / 01
SPEAKERFOUNDRY / TOOL GUIDE

Passive speaker crossover calculators.

Turn a chosen crossover frequency and driver impedance into a starting passive network. SpeakerFoundry supports first through fourth order electrical filters, then lets you explore correction sections in the complete-network calculator.

Open the complete crossover network →Browse all tool guides

Start with the driver and the intended crossover

Choose a frequency from the driver’s measured response and manufacturer guidance. A tweeter’s resonance frequency alone does not establish a suitable minimum crossover. Enter woofer and tweeter load impedance in ohms, then choose a filter alignment.

The design calculator supports first order, second-order Butterworth or Linkwitz–Riley, third-order Butterworth and fourth-order Butterworth or Linkwitz–Riley. Its graph describes electrical voltage across an ideal resistive load.

Read the component values

Inductors are shown in mH and capacitors in µF, with two decimal places for display. Calculations retain precision internally. Compare the calculated values with available components and check their tolerance, voltage and current ratings before building.

As an illustrative calculator input, a first-order 8 Ω branch at 2,500 Hz gives a series low-pass inductor of 0.51 mH or a series high-pass capacitor of 7.96 µF. These are generic design inputs, not specifications or a recommendation for a named driver.

Combine the optional corrections

Complete crossover network lets you choose woofer and tweeter alignment separately. Enable only the notch, baffle-step or L-pad sections you need. The tool solves the combined loaded circuit, so adding a correction can change the filter response.

Check the result with measurements

Real impedance changes with frequency. Driver response, baffle, spacing, polarity, component loss and room placement affect the finished loudspeaker. These ideal calculators do not predict a combined acoustic response or certify driver protection.

When response and impedance files are available, continue with the measured crossover design guide. For a coil you intend to wind, use the inductor winding guide.

Continue your design

Open the complete crossover network →

All SpeakerFoundry tools are free to access. Read the sources, rights and disclaimer.