◉SpeakerFoundryFREE DRIVER RESOURCES / 01
SPEAKERFOUNDRY / TOOL GUIDE

Inductor winding calculator.

Plan a crossover inductor from the inductance you need and the space available for its winding. The calculator estimates whole turns, copper diameter, wire length, resistance and a dimensioned winding preview.

Open the inductor winding calculator →Browse all tool guides

Choose air core or a specified magnetic core

For an air-core winding, enter inside winding diameter and winding length in mm. The calculation uses Wheeler’s multilayer approximation for a round, uniformly wound coil.

For laminated iron, powdered iron or ferrite, supply AL in nH/turn² for the exact core assembly and gap. Also enter mean turn length and usable winding-window area. Selecting a core name does not supply an assumed permeability or certify saturation.

Set the copper and resistance targets

Enter target inductance in mH, design RMS current, allowed current density and maximum target DCR in Ω. Wire diameter means bare copper; enamel thickness is entered separately per side.

Automatic wire selection tries the supported diameters and looks for a winding meeting both current-density and resistance targets. If the returned estimate does not meet them, change the geometry or targets and check the result rather than assuming the coil is suitable.

Understand turns and the drawing

For a specified magnetic core, L in nH equals AL × N². An illustrative 1 mH target with AL = 100 nH/turn² gives 100 turns before practical window, resistance and operating checks. This example is not a specification for an unidentified core.

The preview shows the entered cylindrical winding dimensions and estimated build. Magnetic-core outlines are illustrative; they do not infer a supplier’s exact core shape. Air-core estimates depend on round winding geometry and partly filled outer layers can affect accuracy.

Wind, measure and trim

DCR is estimated at 20 °C. Wire length excludes connection leads; resistance rises as copper heats. Check magnetic-core flux, bias, losses and saturation against the supplier’s data at the intended current and audio frequency.

Measure inductance and DCR after winding, then trim as needed. The estimate does not choose a certified power rating. Return to the complete-network calculator or measured-data workspace to evaluate the coil in its circuit.

Continue your design

Open the inductor winding calculator →

All SpeakerFoundry tools are free to access. Read the sources, rights and disclaimer.