Speaker box and enclosure calculators.
Compare enclosure starting points using driver T/S parameters, net air volume and tuning. SpeakerFoundry includes sealed, ported, fourth- and sixth-order band-pass, passive-radiator and open-baffle tools.
Begin with checked T/S parameters
Fs is entered in Hz, Vas in litres and Qts is dimensionless. Use measured values for the actual unit where possible, particularly a vintage, repaired or aged driver. The catalogue selector offers entries with the three reviewed parameters needed by the relevant forms.
Net air volume excludes drivers, braces and other solid displacement. Keep this separate from the gross interior volume and the external cabinet dimensions.
Choose the enclosure model
- Sealed-box designer: enter Fs, Qts, Vas and target Qtc to estimate volume, system resonance and relative response.
- Ported-box designer: explore net volume and tuning with the linear enclosure model.
- Band-pass designer: compare fourth-order, parallel sixth-order and series sixth-order chamber options.
- Passive-radiator calculator: estimate total and added moving mass from volume, tuning and the radiator’s own Sd, Cms and Mms.
- Open-baffle calculator: explore an effective front-to-rear path difference or a rough flat-baffle geometry estimate.
Turn a tuning target into a physical plan
The round-port calculator estimates length from volume, frequency, bore diameter, count and end correction. Check that the port fits, has clearance and does not consume the intended net volume. Long ports can introduce pipe resonances.
A passive radiator’s required mass is not the same as the amount to add; account for its existing moving mass. If the estimate requires less mass than it already has, the requested tuning may not be achievable by adding weight.
Keep the model’s limits in view
Enclosure graphs are small-signal relative-response estimates. They do not predict maximum SPL, excursion, port velocity or thermal limits. The open-baffle calculation uses opposite point sources and is not a finite-baffle diffraction simulation.
After choosing a volume, use the cabinet and DXF guide to plan panels. Measure the built enclosure and use the measurement guide to review the result.
Continue your design
Open the speaker box calculators →
All SpeakerFoundry tools are free to access. Read the sources, rights and disclaimer.