◉SpeakerFoundryFREE DRIVER RESOURCES / 01
VINTAGE DRIVER REFERENCE

Scan-Speak 25W/8567-SE

Archived Classic woofer with a black anodised aluminium cone, SBR rubber surround and SD-1 motor. The exact 8567-SE sheet specifies an 8-ohm load, 42 mm voice coil and 86.5 dB sensitivity at 2.83 V / 1 m. Its historical revision is kept separate from newer 26W models.

PDF ↗

Driver specifications

Brand
Scan-Speak
Family
Classic
Type
Archived woofer
Nominal size
255 mm overall frame; nominal size not listed
Nominal impedance
8 Ω
Diaphragm
Black anodised aluminium cone
Published sensitivity
86.5 dB. Manufacturer sensitivity at 2.83 V / 1 m. This voltage reference is preserved and is not relabelled 1 W / 1 m.
Published power test
150 W in the manufacturer 100-hour RMS noise test, IEC 60268-5 third edition, clause 17.1. Test bandwidth and filtering are not stated; long-term maximum power is unlisted.
Voice-coil diameter
42 mm
Overall diameter
255 mm
Complete driver mass
2.8 kg
Original document
Original two-page manufacturer archive datasheet updated 22 February 2011
Source checked
2026-10-14

Original drawing: 255 mm outside diameter, 246.5 mm mounting pitch diameter and six 6.5 mm holes. Side view shows 111.5 mm overall axial length and 105 mm behind the front flange. The 227 mm basket dimension is not a recommended finished cutout; machining clearances are not specified.

Thiele/Small parameters

Historical T/S values await independent exact-variant corroboration. The feature list says 20 Hz resonance while the parameter table says 24 Hz, so no resonance value is selected. The preliminary advanced-parameter table is blank.

Sources & availability

Original Scan-Speak datasheet ↗ · Manufacturer archive ↗

Archived exact-model reference outside the reviewed current catalogue. Original production dates and used-unit stock are not established. Confirm condition and original parts before purchase.

Search historical Scan-Speak references →