SpeakerFoundry
VINTAGE DRIVER REFERENCE

JBL LE10A · SB1212

Historical LE10A low-frequency reference from JBL Bulletin SB1212, with an Alnico V motor and cast aluminium frame. Its printed 8–16 Ω impedance label does not establish separate 8 Ω and 16 Ω variants here. Original ratings and geometry are kept with this bulletin.

PDF / documentation ↗

Driver specifications

Brand
JBL
Type
Woofer
Nominal size
10 inches — nominal
Nominal impedance
8–16 Ω as printed; electrical variant unresolved
Original document
JBL Bulletin SB1212; archive dates it circa 1960 (approximate)
Power input / capacity
30 W power capacity with proper acoustic load. The bulletin gives no AES/RMS or continuous-program test standard.
Voice-coil diameter
76.2 mm. Converted from 3 inches; edgewound copper ribbon
Overall diameter
260.35 mm
Front / listed baffle opening
231.775 mm. Front-mount baffle opening from Bulletin SB1212; rear mounting has a different opening.
Rear-mount baffle opening
228.6 mm
Mounting bolt circle
244.475 mm
Overall depth
106.3625 mm. Overall depth in the table; the mounting reference plane is not separately defined.
Mounting depth behind flange
Not established from this source
Maximum recommended crossover
2000 Hz. Published upper recommendation, not a minimum safe crossover or a complete crossover design.
Shipping weight
15 lb. Shipping weight in the table; not the driver net mass.
Source checked
2026-10-16

Original inch dimensions converted at 25.4 mm/in. Conversion decimals do not imply a manufacturing tolerance. Front and rear cutouts are different. Overall depth is distinct from an unverified behind-flange mounting depth.

The bulletin describes direct front mounting and a separate rear-mount opening; confirm the original mounting arrangement before machining.

Construction, mounting & original reference

Open a section for documented details and its original source.

Original enclosure and system context
Enclosure example
Ported enclosure of one cubic foot or greater (approximately 28.3 L), as described in the bulletin
Associated components
LE20 high-frequency transducer and LX4-2 network in the original S11 two-way system
Related system reference
Bulletin identifies the same component set in the Lancer 77

Historical examples, not a current enclosure alignment or replacement recommendation. The original impedance label remains unresolved.

Original technical reference ↗ · SB1212, page 2

Suspension and installation notes
Suspension
Lans-a-loy edge suspension; distinct from the cone and copper-ribbon voice coil
Frame
Cast aluminium frame; bulletin permits direct front mounting for LE10A
Mounting reference
Use the front-mount and rear-mount openings already listed separately in the specifications

A front baffle opening is not the nominal diameter or a behind-flange depth. Original enclosure and crossover conditions remain part of the example.

Original technical reference ↗ · SB1212, pages 1–2

Thiele/Small parameters

Historical T/S values in the original bulletin have not been corroborated in a second credible source for this exact revision; they remain withheld. No values are inferred from photographs or modern replacements.

Technical sources & availability

Original JBL bulletin at Lansing Heritage ↗

Out-of-production historical reference. Used-unit availability, original parts and reconing require individual confirmation.

The original bulletin remains at its external source. Confirm the exact original unit, mounting arrangement and drawing before machining.

Search JBL references → · Vintage driver directory →