JBL D131F · SB1214
Historical 12-inch D131F guitar loudspeaker from JBL Publication SB1214. It uses an edgewound aluminium ribbon coil, aluminium centre dome and cast aluminium frame. D130F and D131F retain separate nominal sizes; specifications of other D130 or D120F variants are not substituted.
Driver specifications
- Brand
- JBL
- Type
- Full-range
- Nominal size
- 12 inches — nominal
- Nominal impedance
- Not stated in the reviewed brochure
- Original document
- JBL Publication SB1214; undated brochure, archive labels circa 1967 (approximate)
- Voice-coil diameter
- 101.6 mm (4 inches)
- Voice-coil material / construction
- Aluminium / Edgewound ribbon
- Frame material
- Cast aluminium
- Centre dome
- Aluminium; 101.6 mm (4 inches)
- Magnetic structure weight
- 11 lb. Original brochure states an eleven-pound magnetic structure shared by D130F and D131F. This is not the magnet alone, net driver mass or moving mass Mms.
- Magnetic return structure
- Low-carbon cast iron. Material of the magnetic return pot assembly; the permanent magnet material is not specified in this brochure.
- Power / sensitivity / response
- Nominal impedance, power rating, sensitivity and a measured frequency range are not stated in SB1214 and remain unlisted.
- Mounting geometry
- Overall frame dimensions, baffle opening and mounting depth have not been established for machining.
- Source checked
- 2026-10-08
Only nominal driver size, voice-coil and centre-dome diameter are stated in the reviewed brochure. Overall diameter, baffle cutout, bolt pattern and mounting depth remain unverified.
Thiele/Small parameters
No corroborated historical T/S dataset is established for this exact brochure reference. No values are inferred from other D130 versions, D120F, modern recones or replacements.
Technical sources & availability
Original JBL literature at Lansing Heritage ↗
Out-of-production original JBL musical-instrument reference. Used-unit availability, original cone assemblies and condition require individual confirmation.
The original document remains at its external source. Confirm the exact unit and original drawing before machining.