JBL 2421A
Original 1982 JBL 2421A 8 Ω compression-driver reference with an Alnico V motor and edgewound aluminium coil. Horn sensitivity, tube sensitivity and crossover-dependent power ratings are kept separate. Original net mass and magnetic assembly specifications are now included.
Driver specifications
- Brand
- JBL
- Type
- Compression driver
- Nominal impedance
- 8 Ω
- Document revision
- JBL Professional Products catalogue, 1982, page 19
- Magnet material
- Alnico V
- Diaphragm material
- Not individually specified in this reviewed catalogue table
- Voice-coil material / construction
- Aluminium / Edgewound ribbon
- Voice-coil diameter
- 44 mm — rounded metric nominal value
- Horn throat diameter
- 25 mm — rounded metric nominal value
- Continuous-program power
- 60 W. Continuous programme: 60 W with an 800 Hz crossover, or 100 W with a 1600 Hz crossover. Catalogue rating depends on crossover frequency.
- Horn sensitivity
- 110 dB SPL. 1 W / 1 m, measured on axis from the mouth of a JBL 2350 90° radial horn (nominal Q 6.3); input swept from the lowest recommended crossover to 2500 Hz. Horn-dependent rating.
- Terminated-tube sensitivity
- 118 dB SPL in a 25 mm (1 inch) terminated plane-wave tube, using 1 mW input swept from the lowest recommended crossover to 2.5 kHz. This is separate from the horn-dependent 1 W / 1 m rating.
- Tube-test voltage
- 0.089 V into 8 Ω for the stated 1 mW test
- Published frequency range
- 800–20000 Hz. Approximate frequency limits at −10 dB; not a flat-response or enclosure F3 specification.
- Lowest recommended crossover
- 800 Hz. The table recommends 800 Hz for the stated rating. Footnote 3 permits operation down to 500 Hz with reduced power capacity between 500 and 800 Hz, but does not give a derated wattage. No full-power 500 Hz rating is inferred.
- Overall diameter
- 146 mm
- Overall depth
- 98 mm
- Mounting depth behind flange
- Not established from this source
- Magnetic assembly mass
- 4.5 kg
- Net driver mass
- 5 kg. Published net driver mass, separately identified from magnetic assembly mass; not shipping weight.
- Magnetic gap flux density
- 1.5 T. Published magnetic gap flux density in tesla; not a Thiele/Small parameter or a free-field response measurement.
- Source checked
- 2026-10-07
Rounded metric overall diameter and depth from the 1982 catalogue. Overall depth is not a verified behind-flange mounting depth; horn attachment geometry requires an original drawing.
Thiele/Small parameters
No independently corroborated complete historical T/S dataset has been established for this exact 1982 variant. Net mass, magnetic assembly mass and gap flux density are source specifications, not substitutes for Mms, BL or other T/S values.
Availability & original sources
Historical model listed in the 1982 JBL catalogue. Current used-unit availability and condition are not tracked.
Original technical reference ↗Source checked 2026-10-07. Manufacturer drawings, photographs and datasheets remain at their external sources.
Search & compare JBL drivers →
Design a crossover from measured response → · Explore cabinet calculators →