◉SpeakerFoundryFREE DRIVER RESOURCES / 01
HISTORICAL DRIVER REFERENCE

JBL 2410

Original 1982 JBL 2410 16 Ω compression-driver reference with an Alnico V motor, edgewound aluminium coil. Horn and tube sensitivity, net driver mass and magnetic assembly mass are identified separately.

PDF / documentation ↗

Driver specifications

Brand
JBL
Type
Compression driver
Nominal impedance
16 Ω
Document revision
JBL Professional Products catalogue, 1982, page 19
Magnet material
Alnico V
Diaphragm material
Not individually specified in the reviewed table
Voice-coil material / construction
Aluminium / Edgewound ribbon
Voice-coil diameter
44 mm — rounded metric nominal value
Horn throat diameter
25 mm — rounded metric nominal value
Continuous-program power
30 W. Continuous-program rating from the 1982 catalogue at its listed minimum crossover; not an AES/RMS or thermal test rating.
Horn sensitivity
110 dB SPL. 1 W / 1 m, measured on axis from the mouth of a JBL 2350 90° radial horn (nominal Q 6.3); input swept from the lowest recommended crossover to 2500 Hz. Horn-dependent rating.
Terminated-tube sensitivity
117 dB SPL in a 25 mm (1 inch) terminated plane-wave tube, using 1 mW input swept from the lowest recommended crossover to 2.5 kHz. Separate from the horn-dependent 1 W / 1 m rating.
Tube-test voltage
0.126 V into 16 Ω for the stated 1 mW test
Published frequency range
800–15000 Hz. Approximate frequency limits at −10 dB; not a flat-response or enclosure F3 specification.
Lowest recommended crossover
800 Hz. The table recommends 800 Hz for the 30 W continuous-program rating. Footnote 3 permits operation down to 500 Hz with reduced power capacity between 500 and 800 Hz, but gives no derated wattage. A full-power 500 Hz rating is not inferred.
Overall diameter
114 mm
Overall depth
98 mm
Mounting depth behind flange
Not established from this source
Magnetic assembly mass
3.4 kg
Net driver mass
3.7 kg. Net driver mass and magnetic assembly mass are separate original catalogue values, not shipping mass or moving mass Mms.
Magnetic gap flux density
1.5 T. Original magnetic-gap flux density in tesla; not the T/S force factor BL.
Source checked
2026-10-08

Rounded metric overall dimensions from the 1982 catalogue. Overall depth is not verified behind-flange mounting depth. Horn attachment geometry requires an original drawing.

Thiele/Small parameters

No independently corroborated complete historical T/S dataset has been established for this exact 1982 variant. Net mass and magnetic assembly mass are not moving mass Mms; gap flux density is not BL. No T/S values are inferred.

Availability & original sources

Historical model listed in the 1982 JBL catalogue. Current used-unit availability and condition are not tracked.

Original technical reference ↗

Source checked 2026-10-08. Manufacturer drawings, photographs and datasheets remain at their external sources.

Search & compare JBL drivers →

Design a crossover from measured response → · Explore cabinet calculators →