SpeakerFoundry
VINTAGE DRIVER REFERENCE

Altec Lansing 755A

Altec 755A full-range vintage driver: steel frame, original baffle opening, mounting context, driver weight and historical sealed-box/EIA conditions.

PDF / documentation ↗

Driver specifications

Brand
Altec Lansing
Type
Full-range
Nominal size
8 inches — nominal
Nominal impedance
8 Ω
Original document
Altec AL-1444-2, brochure copyright 1960; archive’s circa-1968 label is approximate
Voice-coil diameter
50.8 mm
Frame material
Heavy-gauge steel
Magnet material
Alnico V
Power rating
8 W. 8 W in the specification table; engineering text requires at least 8 W continuous. No AES/RMS noise-test method is stated.
Published frequency range
70–13000 Hz. Published endpoints from the original sheet; no numerical response tolerance or measurement enclosure is stated.
Historical EIA sensitivity — on axis
At least 48.5 dB. Minimum on-axis historical EIA sensitivity in the engineering specification. Reference input and distance are not given; not converted to 1 W / 1 m SPL.
Historical EIA sensitivity — 45° off axis
At least 46 dB. Minimum historical EIA sensitivity at 45° off axis. Not an absolute 1 W / 1 m SPL rating.
Magnet weight
1.3 lb
Magnet-weight conditions
Original table magnet weight; engineering requirement at least 1.3 lb. Not driver net mass, whole magnetic assembly mass or Mms.
Magnetic-gap flux density
At least 10000 gauss. Engineering requirement for the magnetic gap, at least 10000 gauss; not BL.
Baffle opening
177.8 mm. Original 7-inch baffle opening. No manufacturing tolerance is supplied.
Mounting depth behind flange
Not established from a dimensioned original drawing
Historical enclosure recommendation
Original brochure recommends a sealed enclosure of two cubic feet (approximately 56.6 L). This historical recommendation is not a T/S-based alignment, verified net volume or modern simulation.
Source checked
2026-10-16

Original 7-inch baffle opening and 2-inch voice coil converted at 25.4 mm/in. Frame/depth and fastening geometry await a clear original drawing; no complete CAD geometry is asserted.

Construction, mounting & original reference

Open a section for documented details and its original source.

Original frame and mounting context
Frame
Heavy-gauge steel
Mounting
Four equally spaced fixing holes
Baffle opening
7 inches (177.8 mm); conversion does not imply machining tolerance
Driver weight
5 lb; distinct from the 1.3 lb magnet
Coil
2-inch (50.8 mm) voice coil

Some small printed frame, depth and bolt-circle fractions still require a clearer original drawing. The 7-inch baffle opening is not the outer frame diameter.

Source documentation ↗ · AL-1444-2, page 2

Original sealed-box and sensitivity context
Cabinet recommendation
Two cubic feet sealed (about 56.6 L), as a historical brochure recommendation
Historical EIA figures
48.5 dB minimum on axis; 46 dB minimum at 45 degrees, with unspecified reference input and distance

EIA figures are not converted to modern 1 W / 1 m sensitivity. A historical cabinet recommendation is not a verified T/S alignment.

Source documentation ↗ · AL-1444-2

Thiele/Small parameters

Historical T/S values remain unlisted until corroborated by two credible sources for this exact original variant. Values from later Altec revisions, modern replacements and individual recones are not substituted.

Technical sources & availability

Original Altec literature at Lansing Heritage ↗

Out-of-production original Altec reference. Used-unit availability, original parts, reconing and condition require individual confirmation.

The original sheet remains at its external source. Confirm the exact unit and original mounting drawing before machining.

Search Altec references → · Vintage driver directory →