SpeakerFoundry
VINTAGE DRIVER REFERENCE

Altec Lansing 515B

Altec 515B vintage 16-ohm woofer: original basket, cloth surround, driver weight, four-point mounting and cabinet/network references.

PDF / documentation ↗

Driver specifications

Brand
Altec Lansing
Type
Woofer
Nominal size
15 inches — nominal
Nominal impedance
16 Ω
Original document
Altec catalogue sheet AL-1411-2; publication date not stated
Voice-coil diameter
76.2 mm (3 inches)
Voice-coil material / construction
Copper / Edgewound ribbon
Frame material
Cast aluminium
Cone material
Moulded fibre
Surround material
High-compliance cloth
Magnet material
Alnico V
Continuous power
35 W. Continuous power rating in the original sheet. No AES/RMS noise-test method or bandwidth is given; this is not relabelled as an AES rating.
Peak power
50 W. Original sheet also states a 50 W peak rating, without a duration or modern peak test protocol.
Pressure sensitivity
103 dB SPL. Published pressure sensitivity on axis at 4 ft (1.2192 m), with 1 W input. Signal bandwidth and enclosure are not specified. This is not a 1 m rating.
Full-power SPL
118.5 dB SPL. Published SPL at 4 ft using the full 35 W continuous rating, separate from the 1 W sensitivity.
Published frequency range
20–1000 Hz. Published frequency-response endpoints in the original sheet; no response tolerance, measurement enclosure or modern test standard is specified.
Magnet weight
4.4 lb. Magnet weight in the original table; not complete magnetic assembly weight, driver mass or moving mass Mms.
Magnetic gap flux density
14750 gauss. Original magnetic-gap flux density, in gauss; not T/S force factor BL.
Mounting geometry
Overall frame dimensions, baffle opening and mounting depth have not been established for machining.
Source checked
2026-10-16

Nominal size and voice-coil diameter are verified. Complete mounting geometry has not been independently checked against a dimensioned original drawing; frame diameter, baffle opening and mounting depth remain unlisted.

Construction, mounting & original reference

Open a section for documented details and its original source.

Original construction and weight
Frame / cone
Reinforced cast-aluminium basket and moulded-fibre cone
Surround
High-compliance cloth with mechanical resistance
Coil
3-inch edgewound copper ribbon
Driver weight
26 lb in the original table; distinct from magnet weight or moving mass
Fixing layout
Four equally spaced mounting holes; confirm the original fractional dimensions before machining

No uncertain printed fraction is entered as a verified machining dimension.

Source documentation ↗ · AL-1411-2, page 2

Original cabinet and HF combinations
Enclosure examples
612B, 614B, 825A, 210 and 410, listed for 803B and 515B
Horn-driver examples
802D / 804A with 511A/B or 811B; 288C / 290D with a suitable multicellular horn
Network examples
N-800D, N-500C and N-500D; the latter is specified with 802D / 804A

Historical combinations only. Match exact network, impedance, horn and cabinet versions; modern replacement equivalence is not established.

Source documentation ↗ · AL-1411-2, page 2

Thiele/Small parameters

Historical T/S values, including free-air resonance, remain unlisted until corroborated by two credible sources for this exact original variant. Later Altec variants and modern replacements are separate. No complete CAD geometry is established.

Technical sources & availability

Original Altec Lansing literature at Lansing Heritage ↗

Discontinued original Altec historical reference. Used-unit availability, reconing and condition require individual confirmation.

The original document remains at its external source. Confirm the exact unit and original drawing before machining.

Search Altec Lansing references → · Vintage driver directory →